Diabetic Supplies

Reliable Diabetes Management

FreeStyle Libre Sensors
Application Guide

Follow these tips when selecting your application site.

Diabetic syringe site

  • Select an area on the back of your upper arm that generally stays flat (no bending or folding). [Figure A]
  • Choose a site that is at least 1 inch (2.5 cm) away from an insulin injection site.
  • Prevent discomfort or skin irritation by selecting a site other than the one most recently used.
  • Make sure the site is clean-shaven to avoid interference with the sensor.

Preparing your skin's surface for optimal adhesion.


Diabetic prep site

  • WASH - Only use non-moisturizing, fragrance-free soap to wash the area where you’ll apply the sensor.
  • CLEAN - Use an alcohol wipe to remove oily residue.
  • DRY - Allow your skin to dry fully before applying the sensor. This is especially important if you plan to apply the sensor after you shower or swim.

What to avoid between your sensor and your skin.


  • Moisture of any kind
  • Hair - consider shaving the application area
  • Oily residue from soap, lotion, shampoo, or conditioner

FreeStyle Libre 2

Always prepare the sensor against a hard, flat surface.

Diabetic Libre 2

  • Peel lid from the sensor pack and unscrew capfrom the sensor applicator.
  • Line up marks on the sensor applicator and pack. Press down firmly on the sensor applicator until it comes to a stop.
  • Lift the sensor applicator out of the sensor pack. The sensor applicator is now ready to apply the sensor.

NOTE: Sensor pack and sensor applicator codes must match or glucose readings may be inaccurate.
CAUTION: Sensor applicators will contain a needle. Do not touch inside sensor applicator or place back inside sensor pack.

FreeStyle Libre 3

Lift the sensor applicator out of the sensor pack. The sensor applicator is now ready to apply the sensor.

Libre 3 application

Follow these steps when applying the sensor:


  • Place the sensor applicator over the application site, press firmly and hold for a few seconds.
  • Gently pull the sensor applicator away from your body.
  • Make sure the sensor is secure by pressing the sensor down and running your finger along the sensor adhesive.

USING THESE PRODUCTS CAN HELP YOU REMOVE YOUR SENSOR


BABY OIL A soft moisturizer.

REMOVE ADHESIVE REMOVER Removes adhesive residue on skin.

UNI-SOLVE ADHESIVE REMOVER Formulated to reduce adhesive trauma to the skin by thoroughly dissolving dressing tape and appliance adhesives.

Diabetic pumps near me

Trust PM Medical Products in Hanover Township / Wilkes-Barre, PA for reliable diabetic products and diabetes management.

The FreeStyle Libre, a small, discreet, and water-resistant sensor, lasts up to 14 days. You can shower, bathe, swim, exercise, or play without any disruption. This sensor continuously measures your glucose levels, eliminating the need for finger pricking day and night.

PM Medical Products offers diabetic products that are designed with accuracy and convenience in mind, ensuring precise readings and ease of use. Our commitment to innovation and high standards makes the diabetic products we carry a dependable choice for effective diabetes management.

With PM Medical Products, you can trust that our diabetic products will provide you with the best tools to maintain your health and well-being.